Mag Fluid Acid Magnetic Centrifugal Pump

Flow capacity: 1.8-400 m3/h

Lift: 15-125m

Highest temperature: 400℃

Pressure: 1.6 MPa.

To transfer chemical medium and acid medium.

1. Structure of suspension type. Support point of sliding bearing, load torque and torsion are in distance piece of joint. Because of the shield and coupling on the magnetic centrifugal pump, it does not need to remove the motor and pipes when maintain the magnetic centrifugal pump, it just needs to uninstall coupling, distance piece and bolts.

With the same installation size of IS and IH centrifugal pump, it is compatible and interchangeable. Sliding bearing, shaft sleeve and thrust bearing are much bigger, safe and reliable.

2. Shroud of IMC chemical process mag centrifugal pump using cross section of stainless steel, Hastelloy alloys, PEEK enhanced by carbide fiber and so on. It improves the efficiency on transmission of magnetic.

3. The wearing parts of the pump are sliding bearing, shaft sleeve and thrust bearing when working. With more wear-resisting, lubricity, higher hardness of tungsten carbide used on wearing parts, it makes the pump working in continuous operation condition. Generally, it can work continuous over 26 months without replace the wearing part. Each fluid magnetic centrifugal pump has over load protection device, which monitors no-load, over load and makes the pump working well. When the magnetic centrifugal pump breaks down, it can cut off the power, reduce to replace wearing parts and maintenance costs.